ACM Home Page
Please provide us with feedback. Feedback
High-speed, scalable, real-time simulation using DSP arrays
Full text PdfPdf (157 KB)
Source Workshop on Parallel and Distributed Simulation archive
Proceedings of the eighteenth workshop on Parallel and distributed simulation table of contents
Kufstein, Austria
SESSION: Optimization table of contents
Pages: 52 - 59  
Year of Publication: 2004
ISBN ~ ISSN:1087-4097 , 0-7695-2111-8
Authors
Roy Crosbie  California State University, Chico, CA, USA
John Zenor  California State University, Chico, CA, USA
Richard Bednar  California State University, Chico, CA, USA
Dale Word  California State University, Chico, CA, USA
Narain Hingorani  Los Altos Hills, CA, USA
Terry Ericsen  Office of Naval Research, Arlington, VA, USA
Sponsors
SIGSIM: ACM Special Interest Group on Simulation and Modeling
TCSIM : IEEE Computer Society Technical Committee on Simulation
SCS : Society for Modeling and Simulation International
Publisher
ACM  New York, NY, USA
Bibliometrics
Downloads (6 Weeks): 7,   Downloads (12 Months): 31,   Citation Count: 2
Additional Information:

abstract   references   cited by   collaborative colleagues  

Tools and Actions: Review this Article  
DOI Bookmark: Use this link to bookmark this Article: http://doi.acm.org/10.1145/1013329.1013339
What is a DOI?

ABSTRACT

Real-time simulation is a familiar technique for testing hardware and software in the loop and for operator training. An important parameter of these simulations is the frame-time necessary to capture the dynamics of the system being simulated. Modern power electronic systems, using higher frequency pulse-width modulation (PWM) converter control demand frame times that are significantly shorter than those found in most real-time simulators. The paper describes an approach to real-time simulation that is capable of achieving the frame times of 10μS and less required for this application. It is a scalable technique that uses arrays of digital signal processors on commercially available boards plugged into a conventional desktop computer. Analog and digital interfaces provide for the connection of real hardware to the simulation. Although the technique has so far been applied only to power electronic systems, it is capable of being used in a wide range of applications in which frame times of less than 10μS are required.


REFERENCES

Note: OCR errors may be found in this Reference List extracted from the full text article. ACM has opted to expose the complete List rather than only correct and linked references.

 
1
R. E. Murray, "Real Time with a Red Hat: Analysis of Standard Linux for Real-Time Simulation" Proceedings of I/ITSEC conference, Orlando, Florida, Dec. 2003. Available on CD ROM from <u>www.iitsec.org/proceedings.cfm</u>
 
2
C. Dufour, J. Bélanger, and S. Abourida, "Accurate Simulation of a 6-Pulse Inverter with Real-Time Event Compensation in ARTEMIS", Electrimacs 2002, Montreal. Available from <u>www.opal-rt.com/downloads/pdfs/33lC Dufour.pdf</u>
 
3
dSPACE Inc., "dSPACE Sets the Pace in HIL Simulation Again", Feb. 2004. <u>www.dspaceinc.com/ww/en/inc/company/press/pr 0402001.htm</u>
 
4
RTDS Technologies Inc. Information available at <u>www.rtds.com/hardware.htm</u>
 
5
M. Kezunovic, "<u>Advanced Modeling Approaches and Simulation Tools for Power Engineering Research and Development,</u>" SCI 2000/ISS 2000, Orlando, July 2000
 
6
M. Kezunovic, J. Domaszewicz, V. Skendzic, M. Aganagic, J. K. Bladow, S. M. McKenna, D. M. Hamai, "<u>Design, Implementation and Validation of a Real-Time Digital Simulator for Protection Relay Testing,</u>" IEEE Transactions on Power Delivery, Vol. 11, No. 1, pp. 158--164, January 1996
 
7
Analog Devices Inc. "Tiger SHARC Processor", <u>www.analog.com/processors/processors/tigersharc/</u>
 
8
R. A. Dougal, S. Liu, L. Gao, M. Blackwelder, "Virtual Test Bed for Advanced Power Sources", <u>J. of Power Sources, Vol. 110, No. 2, pp. 285--294, 09/02.</u>
 
9
B. Lu, W. McKay, S. Lentijo, A. Monti, X. Wu, and R. Dougal, "The Real Time Extension of the Virtual Test Bed", Proceedings of the Huntsville Simulation Conference, Society for Modeling and Simulation International, October 2003, Huntsville, AL., <u>www.scs.org/hsc</u>
 
10
G. S. Thandi, R. Zhang, K. Xing, F. C. Lee, and D. Boroyevich. "<u>Modeling, control and stability analysis of a PEBB based DC DPS</u>" IEEE Transactions on Power Delivery, April 1999, 14(2): 497--505.

Collaborative Colleagues:
Roy Crosbie: colleagues
John Zenor: colleagues
Richard Bednar: colleagues
Dale Word: colleagues
Narain Hingorani: colleagues
Terry Ericsen: colleagues